POE交换机配置样板

1、raisecom 账号raisecom 密码Switch>ena 进入特权模式Switch#show running-config 查看初始信息Ambiguous Command - It may be one of the following :resource rmon running-config Switch#show running-config Building configuration.Current configuration:!version Nservice timestamps log dateservice timestamps debug date!spann

2、ing-tree mode rstpinterface FastEthernet0/1!interface FastEthernet0/2!interface FastEthernet0/3!interface FastEthernet0/4!interface FastEthernet0/5!interface FastEthernet0/6!interface FastEthernet0/7!interface FastEthernet0/8!interface GigaEthernet1/1!vlan 1Switch#config 进入配置模式Switch_config#interfac

3、e gigaEthernet 1/1 进入千兆口Switch_config#switchport mode trunk 配置为trunk模式，并允许所有VLAN通过Switch_config#interface range fastEthernet 0/1 - 8 进入百兆18电口Switch_config_if_range#switchport mode trunk配置为trunk模式，并允许所有VLAN通过Switch_config_if_range#exitSwitch_config#vlan 10,20,100 如：激活AP终端VLAN ID 10，20，及POE交换机本身管理VLAN

4、100Switch_config#interface vLAN 100 进入管理VLAN100Switch_config_v100#no shutdown 激活VLAN100端口 配置POE交换管理IP地址Switch_config_v100#exit 配置网关地址，如网关地址：Switch_config#show running-config 正在收集配置.当前配置:!version Nservice timestamps log dateservice timestamps debug datespanning-tree mode rstpinterface FastEthernet0/1

5、 switchport mode trunk! interface FastEthernet0/2 switchport mode trunk!interface FastEthernet0/3 switchport mode trunk!interface FastEthernet0/4 switchport mode trunk!interface FastEthernet0/5 switchport mode trunk!interface FastEthernet0/6 switchport mode trunk!interface FastEthernet0/7 switchport

6、 mode trunk!interface FastEthernet0/8 switchport mode trunk!interface GigaEthernet1/1 switchport mode trunkinterface VLAN100!vlan 1,10,20,100Switch_config# wr 最后保存配置正在保存当前配置.查看远程供电状态，如下所示：Switch_config#show poe all f0/1 power status: enabled, searching, signal, f0/2 power status: enabled, delivering-power, signal, 接2口f0/3 power status: enabled, searching, signal, f0/4 power status: enabled, searching, signal, f0/5 power status: enabled, searching, signal, f0/6 power status: enabled, searchi