塑料模具专业用语中英文对照

1、模具述语一、入水:gate进入位:gate location水口形式:gate type大水口:edge gate细水口:pin-point gate水口大小:gate size转水口:switching runner/gate唧嘴口径:sprue diameter二、流道 : runner热流道:hot runner,hot manifold热嘴冷流道 : hot sprue/cold runner唧嘴直流 : direct sprue gate圆形流道:round(full/half runner流道电脑分析:mold flow analysis流道平衡 :runner balance热嘴

2、:hot sprue热流道板:hot manifold发热管:cartridge heater探针 : thermocouples插头:connector plug插座:connector socket密封 /封料:seal三、运水:water line喉塞:line lpug喉管:tube塑胶管:plastic tube快速接头:jiffy quick connector plug/socker 四、模具零件:mold components 三板模:3-plate mold二板模:2-plate mold边钉 /导边:leader pin/guide pin边司 /导套:bushing/gu

3、ide bushing中托司:shoulder guide bushing中托边 L :guide pin顶针板:ejector retainner plate托板:support plate螺丝:screw管钉:dowel pin开模槽:ply bar scot内模管位:core/cavity inter-lock顶针:ejector pin司筒:ejector sleeve司筒针:ejector pin推板:stripper plate缩呵:movable core,return core core puller 扣机(尼龙拉勾 :nylon latch lock 斜顶:lifter模胚(

4、架 :mold base上内模:cavity insert下内模:core insert行位(滑块 :slide镶件:insert压座 /斜鸡:wedge耐磨板 /油板:wedge wear plate压条:plate撑头 : support pillar唧嘴:sprue bushing挡板:stop plate定位圈:locating ring锁扣:latch扣鸡:parting lock set推杆:push bar顶板:eracuretun活动臂:lever arm分流锥:spure sperader水口司 :bush垃圾钉:stop pin隔片:buffle弹弓柱:spring rod

5、弹弓 :die spring中托司:ejector guide bush中托边:ejector guide pin镶针:pin销子:dowel pin波子弹弓:ball catch喉塞 : pipe plug锁模块:lock plate斜顶:angle from pin斜顶杆:angle ejector rod尼龙拉勾:parting locks活动臂:lever arm复位键、提前回杆:early return bar 气阀:valves斜导边:angle pin术语:terms承压平面平衡:parting surface support balance模排气:parting line ve

6、nting回针碰料位:return pin and cavity interference模总高超出啤机规格:mold base shut hight顶针碰运水:water line interferes withejector pin料位出上 /下模:part from cavith (core side模胚原身出料位:cavity direct cut on A-plate,core direct cut on B-plate.不准用镶件:Do not use (core/cavity insert用铍铜做镶件:use beryllium copper insert初步(正式模图设计:preliinary (final mold design反呵:reverse core弹弓压缩量:spring compressed length稳定性好:good stability,stable强度不够:insu