IPv6隧道配置.doc

IPv6 Tunneling Configuration | IPv6隧道配置 关键字IPv6隧道配置 IPv6 Tunneling 拓朴实验说明R1,R2,R3在IPv4的OSPF AREA0中现在在R2与R3上实现IPv6的隧道,穿越IPv4核心网 配置R1的配置!hostname R1!interface FastEthernet0/0ip address 172.16.0.1 255.255.255.0duplex half!interface Serial2/1ip address 192.168.0.1 255.255.255.0serial restart-delay 0!router ospf 64log-adjacency-changesnetwork 0.0.0.0 255.255.255.255 area 0!R2的配置!hostname R2!interface Tunnel0no ip addressipv6 address AAAA:1/128tunnel source 192.168.0.2tunnel destination 172.16.0.3!interface Serial2/1ip address 192.168.0.2 255.255.255.0serial restart-delay 0!router ospf 64log-adjacency-changesnetwork 0.0.0.0 255.255.255.255 area 0!ipv6 route :/0 Tunnel0!R3的配置!hostname R3!interface Tunnel0no ip addressipv6 address AAAA:2/128tunnel source 172.16.0.3tunnel destination 192.168.0.2!interface FastEthernet0/0ip address 172.16.0.3 255.255.255.0duplex half!router ospf 64log-adjacency-changesnetwork 0.0.0.0 255.255.255.255 area 0!ipv6 route :/0 Tunnel0!调试R2上进行调试R2#show int t0Tunnel0 is up, line protocol is up Hardware is TunnelMTU 1514 bytes, BW 9 Kbit, DLY 500000 usec, reliability 255/255, txload 1/255, rxload 1/255Encapsulation TUNNEL, loopback not setKeepalive not setTunnel source 192.168.0.2, destination 172.16.0.3Tunnel protocol/transport GRE/IP, key disabled, sequencing disabledTunnel TTL 255Checksumming of packets disabled, fast tunneling enabledLast input 00:06:11, output 00:06:11, output hang neverLast clearing of show interface counters neverInput queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0Queueing strategy: fifoOutput queue: 0/0 (size/max)5 minute input rate 0 bits/sec, 0 packets/sec5 minute output rate 0 bits/sec, 0 packets/sec9 packets input, 972 bytes, 0 no bufferReceived 0 broadcasts, 0 runts, 0 giants, 0 throttles0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort9 packets output, 972 bytes, 0 underruns0 output errors, 0 collisions, 0 interface resets0 output buffer failures, 0 output buffers swapped outR2#show ipv6 tunnel Tun Route LastInp Packets Description0 - 00:06:32 9 R2#show ipv6 routeIPv6 Routing Table - 4 entriesCodes: C - Connected, L - Local, S - Static, R - RIP, B - BGPU - Per-user Static routeI1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS summaryO - OSPF intra, OI - OSPF inter, OE1 - OSPF ext 1, OE2 - OSPF ext 2ON1 - OSPF NSSA ext 1, ON2 - OSPF NSSA ext 2S :/0 1/0via :, Tunnel0LC AAAA:1/128 0/0via :, Tunnel0L FE80:/10 0/0via :, Null0L FF00:/8 0/0via :, Null0R2#ping AAAA:2Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to AAAA:2, tim