健身车曲柄国际花键ISIS标准_图文

1、 THE INFORMATION CONTAINED HEREIN IS INTENDED TO BE PUBLIC DOMAIN. HOWEVER, CHANGES TO THE SPECIFICATIONS CONTAINED HEREIN MAY BE PERFORMED ONLY BY THE ISSUER OF THIS PRINT. PRODUCT NOT IN COMPLIANCE TO THE SPECIFICATIONS CONTAINED HEREIN WILL BE CONSIDERED INCOMPATABLE WITH THIS STANDARDIZED DESIGN

2、. THE DRAWINGS HERE ARE NOT PRODUCT DRAWINGS. THEY ARE TO BE USED AS REFERENCE DOCUMENTS FOR THE DETERMINATION OF FINAL PRODUCTION SPECIFICATIONS. THESE FINAL SPECIFICATIONS ARE THE RESPONSIBILITY OF THE MANUFACTURER WHO INTENDS TO COMPLY WITH THIS GEOMETRY. REV. A B C D REVISIONS DATE 9/5/00 9/12/0

3、0 10/16/00 3/15/01 CHANGES CHANGES IN ITALICS NO CHANGE NO CHANGE NO CHANGE UNLESS OTHERWISE SPECIFIED: DIMENSIONS IN MILLIMETERS EDGE BREAK R 0.10/0.30MM ALL DIAMETERS CONCENTRIC TO SPINDLEBEARING RACES ±0.30 MM REMOVE ALL BURRS ALL DIMENSIONS AFTER FINISHING ISIS DRIVE DRAWN CHECKED APPROVED

4、RELEASED DATE NAME MOROURKE 10-16-00 DATE PN CHAINLINE DATE DATE SIZE REV D A SCALE 1:4 SHEET 5 OF 7 THE INFORMATION CONTAINED HEREIN IS INTENDED TO BE PUBLIC DOMAIN. HOWEVER, CHANGES TO THE SPECIFICATIONS CONTAINED HEREIN MAY BE PERFORMED ONLY BY THE ISSUER OF THIS PRINT. PRODUCT NOT IN COMPLIANCE

5、TO THE SPECIFICATIONS CONTAINED HEREIN WILL BE CONSIDERED INCOMPATABLE WITH THIS STANDARDIZED DESIGN. THE DRAWINGS HERE ARE NOT PRODUCT DRAWINGS. THEY ARE TO BE USED AS REFERENCE DOCUMENTS FOR THE DETERMINATION OF FINAL PRODUCTION SPECIFICATIONS. THESE FINAL SPECIFICATIONS ARE THE RESPONSIBILITY OF

6、THE MANUFACTURER WHO INTENDS TO COMPLY WITH THIS GEOMETRY. REV. D REVISIONS DATE 3/20/01 CHANGES RELEASE UNLESS OTHERWISE SPECIFIED: DIMENSIONS IN MILLIMETERS EDGE BREAK R 0.10/0.30MM ALL DIAMETERS CONCENTRIC TO SPINDLE BEARING RACES ±0.30 MM REMOVE ALL BURRS ALL DIMENSIONS AFTER FINISHING ISIS

7、 DRIVE DRAWN CHECKED APPROVED RELEASED DATE NAME MOROURKE 10-16-00 DATE PN DATE DATE IDEAL SPINDLE USE D SIZE REV A SCALE 1:1 SHEET 6 OF 7 THE INFORMATION CONTAINED HEREIN IS INTENDED TO BE PUBLIC DOMAIN. HOWEVER, CHANGES TO THE SPECIFICATIONS CONTAINED HEREIN MAY BE PERFORMED ONLY BY THE ISSUER OF

8、THIS PRINT. PRODUCT NOT IN COMPLIANCE TO THE SPECIFICATIONS CONTAINED HEREIN WILL BE CONSIDERED INCOMPATABLE WITH THIS STANDARDIZED DESIGN. THE DRAWINGS HERE ARE NOT PRODUCT DRAWINGS. THEY ARE TO BE USED AS REFERENCE DOCUMENTS FOR THE DETERMINATION OF FINAL PRODUCTION SPECIFICATIONS. THESE FINAL SPE

9、CIFICATIONS ARE THE RESPONSIBILITY OF THE MANUFACTURER WHO INTENDS TO COMPLY WITH THIS GEOMETRY. REV. D REVISIONS DATE 3/20/01 CHANGES RELEASE UNLESS OTHERWISE SPECIFIED: DIMENSIONS IN MILLIMETERS EDGE BREAK R 0.10/0.30MM ALL DIAMETERS CONCENTRIC TO SPINDLEBEARING RACES ±0.30 MM REMOVE ALL BURRS ALL DIMENSIONS AFTER FINISHING IS