航发pcf1报告半尺寸.part1mp gean-prod gusset cowl rr rh

1、CS11_Fully measured ReportProject Name Part Number CAD NumberProduct Name:CS11:_006: GEAN-PROD-GUSSET COWL RR RH立衡科技r:VCC Material standards : VDA 239-CR240LA Actual Material : CR240LAThickness: 1.3mmCoating thickness : GI50/50-U Detection time :2017/01/16CHECK RESULT 检查结果CHECK DATE检测日期OK.RATIOPart

2、codeP1TOTAL全尺寸OK Ratio100%OK Pos63Total Pos63SURF.型面OK Ratio100%OK Pos47Total Pos47TRIM修边OK Ratio100%OK Pos15Total Pos15HOLE孔位孔径OK Ratio100%OK Pos1Total Pos1RPS InformationStep 1 : Surface CheckingStep 2 : Trim CheckingStep 3 : HolesitionStep 4 : Hole size Checkingnominalactualdeviationnominalactual

3、deviationRPS1Step 5 : ThinningREPORT CHECKING THINNESMeasure thickness request: 1.3 mmactual thicknessmmLIMITS MAX : 20%11.254%21.226%31.235%41.263%51.263%678910111213141516THINNING MAXStep 6 : Appearance CheckingAppearance Checking 外观检查NO判定标准Control standard检验方法Methond判定OK、NG、N/APicture1零件是否正确？Is t

4、he rignt part?Visual目视ok2变薄率是否 料厚的 20%范 内？THINNING MAX no more 20%Venire caliper 游标卡尺ok3是否有开裂、暗裂？No crack,deformationVisual目视ok4毛边、毛刺、尖角是否 0.3mm 范围内？glitches, indenion,damaged,Venire caliper 游标卡尺ok5是否有模痕、压伤（无手感可接受）？No roughness detect with the handwith the handok6是否有拉伤、划伤？No degradation or deformati

5、on手触 with the handok7是否有起皱、变形（装配面平面度需0.2MM 以内）？No crack,deformationVisual /Venire caliper目视/游标卡尺ok8是否有生锈？Rust?Visual目视ok9字印是否正确、明显且无手 感？Marking information crrect ?Visual/ with the hand目视/手触ok10公差是否与 3D 公差相符？Report tolerance is the same with 3D?检查 checkingok11零件定位是否与检具定义相符？PRS is the same with gauge?检具 gaugeok12料边断差是否超过公差带的 50%？ Trim no moren 50% out of tolerance?目视/检