升级器-软件方法说明

1、 MST 106 Update Directions(1)升级说明(1)： 最先安装USB驱动程序（CDM_Setup）如果安装后下次使用时不用再安装此驱动。运行ISP_Tool 4.4.0.4再将USB 升级工具联上电脑和机器。如下图：Firstly install USB drive software（CDM_Setup）and you dont need to install it again when next time you use it.Open ISP_Tool 4.4.0.4 and then connect the USB update tool between compu

2、ter and LCD TV as the illustration below: (1 OR 2)1 122步骤一：打开烧录工具，点connect，此工具能自动识别Flash的型号和大小。Step one：Open the update program tool and click “connect”. This program can auto-check the model and the volume of the Flash. 步骤二：点击Read,将待烧录的文件导入 Step two：Click “Read” to lead in the software.步骤三：点击Auto，将

3、“Blank, Program, Verify, Exit ISP”勾上，一般情况下只勾“Program, Exit ISP”也可烧录，这样速度会快一点。最后点击“Run”，就OK了。Step three：Click “Auto” and tick off “Blank, Program, Verify, Exit ISP”. (Usually it can work and be quick when only ticking off “Program,Exit ISP”) Finally click “Run” is OK.注意：106和澳洲高清的程序都很大，烧录时间比较长，大约3-4分钟

4、； 另外，烧录第一步时经常遇到连接不上，不要慌，只需将USB接口插拔几次或者将此软件关掉再点开几次，一般来说就没什么问题了。Warnings：For the volume of the 106 and Australia HD software are all big, it will take long time to update about 34 minutes. In addition, in the step one usually it will show connect is failed. Dont worry and you can just push and pull the USB several times or you can close the program tool and open it several times, then it should be ok. MST 106 Update Directions(2)升级说明(2)： USB Update1，准备一条USB线和一个U盘（如下图） 1PCS USB CABLE ADN USB DISK（as the illustration below）2，将电视开机并将SOURCE 选为DTV3，将升级程序拷入U盘，文件名命名为usb，将USB CABL