澳规插头尺寸

2.2.3 - Form of pin The exposed ends and the contact portion of plug pins shall be smooth and free from openings or indentations;Result:The form of pin belongs to (h / i / j) typeLocationsSize (mm)Tolerance (mm)Measured (for both pins, if applicable) (mm)R0.350.05S0.90.1T0.60-V6-2.2.4 Insulation of plug pins2.8.1 & 2.8.4 Compliance with dimensional requirements of Figure 2.1Method: Plugs up to 15 A complying with Figure 2.1(a), 2.1(c) or 2.1(f) (flat live pins) and of the insulated pin plug type do not need to comply with the R20.0 1 mm requirement of Figure 2.1(e). In addition to the dimensions of Figure 2.1, the distance between a live pin of any plug and the edge of the moulding of the plug, shall be not less than 9 mm. No point on the front face of the plug shall protrude by more than 0.5 mm. Using a 1.5 mm feeler gauge of greater than 3 mm width and applied without undue force between the plug and the plug gauge, penetration to within 9 mm of the live pin shall not be possible. compliance with the nominal dimensions covering disposition of pins, i.e. spacing from centre and angular orientation, shall be checked by a gauge complying with Appendix A, as appropriate.Result:1. the distance between a live pin of any plug and the edge of the moulding of the plug, was measured _ mm2. The 1.5 mm feeler gauge (can / can not) penetration to within 9 mm of the live pin LocationsSize (mm)Tolerance (mm)Measured (for both pins, if applicable) (mm) A6.350.15C (both pins)1.630.15D (nominal)7.92-(check by gauge)F17.060.4G 8.6-1 21.9 max. or 27.0 min.-221.9 max. or 27.0 min.-321.9 max. or 27.0 min.-421.9 max. or 27