02-A 遵循标准.doc

OptiX OSN 9500产品描述目 录目 录A 遵循标准A-1A.1 ITU-T相关标准A-1A.2 IEEE相关标准A-3A.3 IETF相关标准A-3A.4 环境相关标准A-3A.5 国家相关标准A-5A.6 EMC相关标准A-6文档版本 01 (2007-12-31)华为技术有限公司iOptiX OSN 9500产品描述A 遵循标准A 遵循标准本章列出了OptiX OSN 9500遵循的各种标准。A.1 ITU-T相关标准ITU-T相关标准说明G.691Optical interfaces for single-channel STM-64 system and other SDH systems with optical amplifiersG.692Optical interfaces for multichannel systems with optical amplifiersG.694.1Spectral grids for WDM applications: DWDM frequency gridG.694.2Spectral grids for WDM applications: CWDM wavelength gridG.702Digital hierarchy bit ratesG.703Physical/electrical characteristics of hierarchical digital interfacesG.704Synchronous frame structures used at 1544, 6312, 2048, 8448 and 44736 kbit/s hierarchical levelsG.707Network node interface for the synchronous digital hierarchy (SDH)G.775Loss of signal (LOS) and alarm indication signal (AIS) defect detection and clearance criteriaG.773Protocol suites for Q-interfaces for management of transmission systemsG.774 1G.774 2G.774 3G.774 4G.774 5Synchronous Digital Hierarchy (SDH) management information model for the network element viewG.781Synchronization layer functionsG.783Characteristics of Synchronous Digital Hierarchy (SDH) equipment functional blocksG.784Synchronous Digital Hierarchy (SDH) managementG.803Architectures of transport networks based on the Synchronous Digital Hierarchy (SDH)G.806Characteristics of transport equipment - Description methodology and generic functionalityG.813Timing characteristics of SDH equipment slave clocks (SEC)G.823The control of jitter and wander within digital networks which are based on the 2048kbit/s hierarchyG.824The control of jitter and wander within digital networks which are based on the 1544kbit/s hierarchyG.825The control of jitter and wander within digital networks which are based on the Synchronous Digital Hierarchy (SDH)G.826Error performance parameters and objectives for international, constant bit rate digital paths at or above the primary rateG.831Management capabilities of transport networks based on the Synchronous Digital Hierarchy (SDH)G.841Types and characteristics of SDH network protection architecturesG.842Cooperation of the SDH network protection structuresG.957Optical interfaces of equipments and systems relating to the synchronous digital hierarchyQ.811Lower layer protocol profiles for the Q3-interfaceQ.812Upper layer protocol profiles for the Q3-interfaceM.3010Principles for a telecommunication management networkG.661Definition and test methods for the relevant generic parameters of optical fibre amplifiersG.662Generic characteristics of optical fiber amplifier devices and sub-systemsG.663Application related aspects of optical fibre amplifier devices and sub-systems X.86Ethernet over LAPS G.7041Generic framing procedure (GFP)G.7042Link capacity adjustment scheme (LCAS)G.7710Common equipment management function requirementsI.610B-ISDN operation and maintenance principles and functionsA.2 IEEE相关标准IEEE相关标准说明IEEE Std 802.3 -2005Carrier sense multiple access with collision detection (CSMA/CD) access method and physical layer specificationA.3 IETF相关标准IETF（Internet Engineering Task Force）相关标准说明RFC2615(1999)PPP (Point-to-Point Protocol) over SONET/SDHRFC1662(1994)PPP in HDLC-like FramingRFC1661(1994)The Point-to-Point Protocol (PPP)A.4 环境相关标准环境相关标准说明EN 300 386 V1.3.3Electromagnetic compatibility and Radio spectrum Matters (ERM); Telecommunication network equipment; Electromagnetic Compatibility (EMC) requirementsEN 55022Limits and methods of measurement of radio disturbance characteristics of information technology equipmentEN 55024Information technology equipment-Immunity characteristics-Limits and methods of measurement.EN 61000-4-2Electromagnetic compatibility (EMC); Part 4: Testing and measurement techniques; Section 2: Electrostatic discharge immunity testEN 61000-4-3Electromagnetic compatibility (EMC); Part 4: Testing and measurement techniques; Section 3: Radiated, radio-frequency, electromagnetic field immunity testEN 61000-4-4Electromagnetic compatibility (EMC); Part 4: Testing and measurement techniques; Section 4: Electrical fast transient/burst immunity testEN 61000-4-5Electromagnetic compatibility (EMC); Part 4: Testing and measurement techniques; Section 5: Surge immunity testEN 61000-4-6Electromagnetic compatibility (EMC); Part 4: Testing and measurement techniques; Section 6: Immunity to conducted disturbances, induced by radio-frequency fieldsEN 61000-4-29Electromagnetic compatibility (EMC)-Part4-29: Testing and measurement techniques-Voltage dips, shot interruptions and voltage variations on d.c. input power port immunity tests.ETSI EN 300 132-2Power supply interface at the input to telecommunications equipment; Part 2: Operated by direct current (dc).ETSI ES 201 468 V1.3.1Electromagnetic compatibility and Radio spectrum Matters (ERM); Additional Electromagnetic Compatibility (EMC) telecommunications equipment for enhanced availability of service in specific applications.ETSI EN 300 019-1Environmental Engineering (EE); Environmental conditions and environmental tests for telecommunications equipment; Classification of environmental conditionsETSI EN 300 019-2Environmental Engineering (EE); Environmental conditions and environmental tests for telecommunications equipment; Specification of environmental testsETSI EN 300 753Equipment Engineering (EE); Acoustic noise emitted by telecommunications equipmentIEC 60068-1Environmental testing; Part 1: General and guidanceIEC 60068-2Basic environmental testing procedures; Part 2: TestsIEC 600721-1Classification of environmental conditions-Part 1: Environmental parameters and their severitiesIEC 600721-2Classification of environmental conditions-Part 2: Environmental conditions appearing in natureIEC 600529Degrees of protection provided by enclosures (IP code)QM333Specification for environmental testing of electronic equipments for transmission and switching use (An Indian standard)GR-63NEBS requirements: physical protectionGB/T 2423Environmental testing for electric and electronic productsYD5083-99Interim provisions for test of anti-seismic performances of telecommunications equipmentA.5 国家相关标准国家相关标准说明YDN028-1997SDH光缆系统及设备的线性复用段保护线性复用段、自愈 环及其它类型结构YDN 062-1997PDH通道、段和传输系统及SDH通道和复用段的故障检测和定位程序GB/T 13543-92数字通信设备环境试验方法GB 2421-89电工电子产品基本环境试验规程总则GB 2423.1-89电工电子产品基本环境试验规程试验A：低温试验方法GB 2423.2-89电工电子产品基本环境试验规程试验B：高温试验方法GB/T 2423.3-93电工电子产品基本环境试验规程试验Ca：恒定湿热试验方法GB 2423.4-1993电工电子产品基本环境试验规程试验Db：交变湿热试验方法GB/T 2423.5-1995电工电子产品环境试验 第二部分：试验方法试验Ea和导则：冲击GB/T 2423.6-1995电工电子产品环境试验 第二部分：试验方法试验Eb和导则：碰撞GB 2423.9-89电工电子产品基本环境试验规程试验Cb：设备用恒定湿热试验方法GB/T 2423.10-1995电工电子产品环境试验 第二部分：试验方法试验Fc和导则：振动 （正 弦）GB 2423.22-87电工电子产品基本环境试验规程 试验N：温度变化试验方法GB 2423.43-1995电工电子产品环境试验 第二部分：试验方法 元件、设备和其他产品在 冲击（Ea）、碰撞（Eb）、振动（Fc和Fd）和稳态加速度（Ga）等动力学试验中的安装要求和导则GB2424.1-89电工电子产品基本环境试验规程 高温低温试验导则GB/T2424.2-93电工电子产品基本环境试验规程 湿热试验导则GB2424.13-81电工电子产品基本环境试验规程 温度变化试验导则SJ2170-82SJ2175-82一般电子产品运输包装基本试验方法SJ 3213-89SJ 3215-89一般电子产品运输包装基本试验方法SJ/Z 3216-89电子产品防护、包装和装箱等级GB 3873-83通信设备产品包装通用技术条件GB/T 4857.1-92包装、运输包装件试验时各部位的标示方法GB/T 14013-92移动通信设备 运输包装GB191-1990包装储运图示标志GB6388-1986运输包装收发货标志GB/T 13426-1992数字通信设备的可靠性要求和试验方法A.6 EMC相关标准EMC相关标准说明IEC 61000-4-2EN 61000-4-2Electromagnetic compatibility-Part4-2：Testing and measurement techniques-Electrostatic discharge immunity testIEC 61000-4-3EN 61000-4-3Electromagnetic compatibility (EMC)-Part 4-3: Testing and measurement techniques-Radiated, radio-frequency, electromagnetic field immunity testIEC 61000-4-4EN 61000-4-4Electromagnetic compatibility (EMC)-Part 4-4: Testing and measurement techniques-Electrical fast transient/burst immunity testIEC 61000-4-5EN 61000-4-5Electromagnetic compatibility (EMC)-Part 4-5: Testing and measurement techniques-Surge immunity testIEC 61000-4-6EN 61000-4-6Electromagnetic compatibility (EMC)-Part 4-6: Testing and measurement techniques-Immunity to conducted disturbances, induced by radio-frequency fieldsIEC 61000-4-29EN 61000-4-29Electromagnetic compatibility (EMC)-Part 4-29: