来料检验规范3_第1页
来料检验规范3_第2页
来料检验规范3_第3页
来料检验规范3_第4页
来料检验规范3_第5页
已阅读5页,还剩1页未读 继续免费阅读

下载本文档

版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领

文档简介

1、 杜仲叶论文:一种新型杜仲冲剂的生产工艺研究【中文摘要】杜仲(Eucommia ulmiodes Oliv.)为单属科单种属植物,其皮和叶中含有多种药用成分,如绿原酸、黄酮、桃叶珊瑚苷,多种维生素、氨基酸,丰富的矿物质铁、钙、钾、锌、镁、硒等天然植物微量元素,具有调节血压、血脂和血糖,抗氧化、抗衰老及抗肿瘤,增强免疫力,减肥美容等保健作用。本研究对杜仲有效成分提取工艺进行了深入的研究,优化了提取工艺,提取出了富含生物活性物质的浸膏。在此基础上,研究了杜仲冲剂的造粒工艺,为新型杜仲保健品和药品的开发提供理论依据。研究结果如下:一、杜仲叶有效成分提取工艺以杜仲叶中的生物活性物质绿原酸和总黄酮为指标

2、,利用响应面法优化提取杜仲叶中的工艺参数。在分析单因素的基础上,以绿原酸和总黄酮的得率为响应值,以乙醇浓度(%)、提取温度()、提取时间(h)、料液比为考察因素,并采用响应面设计实验方法优化提取工艺,其最优条件为乙醇浓度55%、提取温度63、提取时间2.2h、料液比为1:13。在此条件下,绿原酸和总黄酮的得率分别达0.81%和0.51%。二、杜仲冲剂的制备工艺通过一系列的单因素试验选择不同的矫味剂、赋型剂、润湿剂,并从实际生产中常用的制粒方法湿法制粒、快速搅拌制粒、流化喷雾制粒中选择快速搅拌制粒为主要的制粒方法。以粒度不合格率为响应值,确定最佳提取工艺参数为:甜菊糖苷用量为杜仲提取物的0.78

3、%、-环状糊精与药粉质量之比为6,乙醇浓度为65%,乙醇用量(L)与药粉量(kg)比例为l6,干燥温度为70,在此条件下,杜仲冲剂的颗粒不合格率为仅为6.12%。通过本课题的研究,得到了完整的一套杜仲冲剂制备工艺:杜仲叶经除尘、除杂,并于105杀青10min后晾干,粉碎,加入55%乙醇,乙醇用量(L)与杜仲叶(kg)比例为131,在63的温度下提取2.2 h后,在60下浓缩、干燥,得到杜仲提取物干粉,粉碎,加用量为杜仲提取物干粉的0.78%的甜菊糖苷、6倍于其他药粉重量的-环状糊精、并加入浓度为65%的乙醇,乙醇用量(L)与药粉量(kg)比例为l6,混合均匀后,倒入快速搅拌制粒机中制粒,而后在

4、70下进行干燥,时间为20 min,成型后即为杜仲冲剂。【英文摘要】Eucommia ulmiodes Oliv. is a plant species with mono genus and family. The bark has been a traditional Chinese medicine for thousands of years. Modern scientific research has confirmed that the functional constituents in the leaf are similar to the bark. Based on th

5、is finding, the leaf has been listed in China Pharmacopoeia with therapeutic effects similar to the bark. The leaf contains a variety of medicinal ingredients, such as chlorogenic acid, flavonoids, aucubin, vitamin, amino acids, and minerals. The medical functions of the leaf include regulating bloo

6、d pressure, lipids and glucose, anti-oxidation, anti-aging, anti-tumor, enhancing immunity, beautifying skin and anti-obesity.In order to make health-care products from the leaves of E. ulmoides, an experiment was conducted on the optimization of the extraction parameters of active ingredients the g

7、ranulation process of the extracts which are rich in functional constituents. The results are as follows.1. Extraction of active ingredients of leaves of Eucommia ulmoidesResponse surface methodology (RSM) was employed to optimize the extraction parameters of chlorogenic acid and flavonolds from the

8、 leaves of E. ulmoides. Based on one-factor experiment, the effects of four independent variables, namely the concentration of ethanol (%) extraction temperature (°C), time (h) and the ratio of material to solvent on the extraction yields of chlorogenic acid and flavonoids were investigated, an

9、d then the response surface analysis was used to optimize conditions. The optimal extraction parameters were: ethanol concentration: 55%, extraction temperature: 63°C, time of extraction: 2.2h and material to solvent 1:13 according to the response surface analysis. Under these conditions, the e

10、xtraction yields of chlorogenic acid and flavonoids were 0.81%, 0.51% respectively.2. Development of Eucommia granulesFirstly, optimal additives were screened from different flavoring agents, excipients, and wetting agents. Then preferable method of granulation was selected from three conventional m

11、ethods, namely, fast stirring granulation, wet granulation, rapid mixing granulation, and fluidized spraying granulation. Failure rate of particle size was investigated and then the response surface analysis was used to optimize conditions. The optimal extraction parameters were: 0.78% stevia,-cyclo

12、dextrin to powder: 6, 65% ethanol concentration, ratio of ethanol (L) to the powder volume (kg) 1:6, drying temperature of 70°C, in these conditions, Eucommia granules failure rate of particles size was as low as 6.12%.Based on the results mentioned above, a completed flow of making Eucommia gr

13、anules were proposed as Eucommia leaf after de-dusting, cleaning, and drying 10 min at 105°C, grinding, added 55% ethanol, and the ratio of ethanol (L) to Eucommia leaf (kg) 13:1, and extracted at 63°C about 2.2h, next, concentrated and dried at 60°C. After grinding, the Eucommia leaf

14、 extract powder added 0.78% stevioside, the-cyclodextrin which was 6 times of the weight of other powder, then continued to add 65% ethanol, and concentration of ratio of ethanol (L) to the powder volume (kg) l:6, after mixing, granulated into the machine the rapid mixing granulation, and then dried

15、 under 70°C, 20 minutes.【关键词】杜仲叶 绿原酸 响应面 提取 造粒 颗粒不合格率【英文关键词】Eucommia ulmoides leaf chlorogenic acid flavonoids response surface extraction granulation failure rate of particles【目录】一种新型杜仲冲剂的生产工艺研究摘要5-6ABSTRACT6-7第一章 文献综述10-181.1 杜仲简介101.2 杜仲叶的活性成分10-121.2.1 绿原酸101.2.2 黄酮类化合物10-111.2.3 环烯醚萜类化合物11

16、1.2.4 杜仲多糖11-121.3 杜仲中的营养成分121.3.1 氨基酸121.3.2 维生素121.3.3 矿物质121.4 杜仲叶的保健作用12-151.4.1 调节血压、血脂和血糖作用12-131.4.2 抗氧化,抗衰老及抗肿瘤作用13-141.4.3 增强免疫力141.4.4 减肥美容14-151.5 杜仲叶的开发研究现状151.6 药物剂型的选择15-181.6.1 固体剂型15-161.6.2 液体制剂16-171.6.3 半固体及其他制剂17-18第二章 杜仲叶有效成分提取工艺18-302.1 材料与方法192.1.1 材料192.1.2 主要试剂192.1.3 主要仪器192.2 试验方法19-202.2.1 工艺流程192.2.2 绿原酸检测方法19-202.2.3 总黄酮的检测方法202.2.4 单因素试验202.2.5 响应面优化202.2.6 数据的统计及分析202.2 结果与分析20-232.2.1 单因素试验分析20-222.2.2 提取工艺的分析及回归方程的建立22-232.3 数据处理23-292.3.1 回归方程23-242.3.2

温馨提示

  • 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
  • 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
  • 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
  • 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
  • 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
  • 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
  • 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

评论

0/150

提交评论