关 键 词：

3503-2007 石油化工建设工程项目交工技术文件规定 石油化工建设工程项目交工技术文 3503-2007石油化工建设工程项目交工技术 SH3503-2007

资源描述：

SH3503-2007石油化工建设工程项目交工技术文件规定中英文对照表格,3503-2007,石油化工建设工程项目交工技术文件规定,石油化工建设工程项目交工技术文,3503-2007石油化工建设工程项目交工技术,SH3503-2007

内容简介：

SH 3503J204块体式设备基础允许偏差项目复测记录Re-measurement for Items of Allowable Deviation on Foundation Using Lump Equipment工程名称：Project Description:单元名称：Unit Description:施工单位Construction Unit基础名称Name of Foundation图号Drawing No复测日期Date of Re-measurement 年(Y)月(M)日(D)复 测 项 目Item of Re-measurement允许偏差(mm)Allowable Deviation各 检 查 点 实 际 偏 差 (mm)The Actual Deviation in the Points Measured123456789101轴线位置Position of Axis纵轴线Longitudinal axis202横轴线Transversal axis203基础不同平面的标高（不计表面灌浆层高度）Elevations of Foundation Surfaces (Excluding Grouting Layer Height) 0-204基础平面外形尺寸Dimension of Foundation Surfaces20基础凸台上平面外形尺寸Dimension of Surfaces on Prominent Foundation 0-20基础凹穴尺寸(包括平面内的内部孔、沟、坑等)Dimension of Foundation Concavity (Including the hole, Fossa, and pit under the surfaces)+20 05基础平面的水平度（包括地坪上需安装设备部分）Levelness of Foundation Surfaces (Including the section for installation of equipments on ground)每米Per Meter5全长Total Length106基础侧面垂直度Foundation side Verticality每米Per Meter5全长Total Length107预埋地脚螺栓Preserved anchor bolts标高（顶端）Elevation (Top)+10 0中心距(在根部和顶部两处测量)Center Distance (Measured at the bottom and the top)28地脚螺栓预留孔ObligatoryPreserved Holes for AnchorFoundation Bolts中心位置Center Location10深 度Depth+20 0孔壁垂直度Verticality of Hole Wall109预埋活动地脚螺栓锚板Grapping Panel Obligatory for Embedded FoundationAnchor Bolts and Anchor Plate标 高Elevation+20 0中心位置Center Location5水平度Levelness带槽的锚板Grappling PanelAnchor Plate with Grooves5带螺纹孔的锚板Anchor PlateGrappling Panel with Threaded Holes2注Note：检查点位置见附图Refer to the attached sketch for the locations of inspection points.。复测结果确认Conformation on the Result of Re-measurement:接收单位Acceptance Unit建设 / 监理单位Owner Construction/ Supervisoryion Unit交出单位 Delivery Unit 专业工程师： DisciplineProfessional Engineer: 年(Y) 月(M) 日(D) 专业工程师： Discipline Professional Engineer: 年(Y) 月(M)